D-Link 5000 Series Cli Reference Manual page 669

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
Default
The default is None.
Command Mode
Privileged EXEC
Example
The following shows example CLI display output for the command.
(Router)#show ip route ecmp-groups
ECMP Group 1 with 2 next hops (used by 1 route)
172.20.33.100 on interface 2/33
172.20.34.100 on interface 2/34
ECMP Group 2 with 3 next hops (used by 1 route)
172.20.32.100 on interface 2/32
172.20.33.100 on interface 2/33
172.20.34.100 on interface 2/34
ECMP Group 3 with 4 next hops (used by 1 route)
172.20.31.100 on interface 2/31
172.20.32.100 on interface 2/32
172.20.33.100 on interface 2/33
172.20.34.100 on interface 2/34
7-40 show ip route hw-failure
Display the routes that failed to be added to the hardware due to hash errors or a table full condition.
show ip route hw-failure
Parameters
None
Default
The default is None.
Command Mode
Privileged EXEC
Example
The following example displays the command output.
(Routing)(Config)#ip route net-prototype 66.6.6.0/24 9.0.0.2 4
(Routing)#show ip route connected
663