D-Link 5000 Series Cli Reference Manual page 118

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
(Routing)(Config)#radius server key acct 10.240.4.10 encrypted encrypt-string
4-129 radius server msgauth
This command is used to enable the use of the message authenticator attribute by the specified RADIUS
Authenticating server.
The no command is used to disable the use of the message authenticator attribute by the specified
RADIUS Authenticating server.
radius server msgauth {ipaddr | dnsname}
no radius server msgauth {ipaddr | dnsname}
Parameters
ipaddr
dnsmane
Default
The default is None.
Command Mode
Global Config
4-130 radius server primary
This command is used to specify the configured server that will serve as the primary server among a
group of servers that share the same server name. It should be noted, however, that multiple such
primary servers can be configured for any group of servers that share the same name. The RADIUS client
will, by default, use the primary server that has the specified server name in the event that the client is
asked to perform transactions with an authenticating RADIUS server of a specified name. The RADIUS
client will only use the backup servers configured with the same server name if it fails to communicate
with the primary server for any reason. Such backup servers are identified as secondary servers.
radius server primary {ipaddr | dnsname}
Parameters
ipaddr
dnsmane
Default
The default is None.
Indicates the IP address of the server.
Indicates the DNS name of the server.
Indicates the IP address of the server.
Indicates the DNS name of the server.
112