D-Link 5000 Series Cli Reference Manual page 157

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
This command is used to show information regarding the interface, including its description, speed, port
state, and auto-neg capabilities. It is similar to the show port all command, but it also shows additional
fields such as the interface description and port-capability.
The interface description itself can be configured through the existing command description <name>, the
maximum length of which is 64 characters that are truncated to 28 characters in the output. Using show
port description allows the long form of the description to be displayed. The interfaces for which
information is displayed by this command include the physical interfaces, LAG interfaces, and VLAN
routing interfaces.
show interfaces status [{slot/port | vlan id | all | lag}]
Parameters
slot/port
vlan id
all
lag
Default
The default is None.
Command Mode
Privileged EXEC
Example
The following is an example of the CLI display output for the command.
(Routing #show interfaces status 0/1
Port Name Link
State
----- ----- -----
0/1 Down
Flow Control:Disabled
Display Parameters
Port
Name
Link State
Physical Mode
Physical Status
(Optional) Select a slot/port to display its status.
(Optional) Select a VLAN interface.
(Optional) Select to display all interfaces.
(Optional) Select a lag interface.
Physical Physical
Mode Status
----- ----------
25G Full
Indicates the interface that is associated with the rest of the data shown
in the row.
Indicates the descriptive user-configured name for the given interface.
Indicates whether or not the link is up.
Indicates the duplex and speed settings on the given interface.
Indicates the duplex mode and port speed for physical interfaces,
although the physical status of LAGs is not reported. In the event that a
port is down, its physical status will be unknown.
151
Media Flow Control
Type Status
---------- ----------
25G-BaseSX Inactive