D-Link 5000 Series Cli Reference Manual page 608

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
default, the connection mode is SSL. The controller table that is configured by this command will be used
by the switch in the OpenFlow 1.0/1.3 modes.
The no command is used to delete the specified OpenFlow Controller IP address or to delete all of the
Controller addresses. All of the entries for the specified IP address will be deleted if the IP Port number is
omitted.
openflow controller ip-address [ip-port] [connection mode]
no openflow controller {ip-address [ip-port] | all}
Parameters
ip-address
portid
connection mode
all
Default
The default is as follows: 6633 (adding), all (deleting).
Command Mode
Global Config
6-32 openflow default-table
This command is used to configure the Hardware Table that will be used as the target for any flows
transmitted by an OpenFlow 1.0 controller that has not been enhanced to handle multiple hardware tables.
The parameter can only be applied when the OpenFlow variant is set to OpenFlow 1.0.
openflow default-table parameter
Parameters
parameter
Default
The default is Full-match.
Command Mode
Global Config
Specify up to twenty IP addresses to which the switch should establish
an OpenFlow Management connection.
lP port to use for an OpenFlow Management connection. If the IP Port is
omitted, then the default IP port number 6633 is used.
TCP or SSL. The default is SSL.
Indicates deleting.
Possible values are full-match or layer-2-match.
602