D-Link 5000 Series Cli Reference Manual page 34

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
Default
The default is None.
Command Mode
Privileged EXEC
4-14 serviceport ipv6 gateway
This command is used to configure the IPv6 gateway (i.e. default router) information for the service port.
The no command is used to remove IPv6 gateways on the service port interface.
Note: For the service port, only a single IPv6 gateway address can be configured. It is possible for there
to be a combination of explicitly configured IPv6 prefixes and gateways and IPv6 prefixes and gateways
that are set through auto-address configuration via a connected IP router on their service port interface.
serviceport ipv6 gateway gateway-address
no serviceport ipv6 gateway
Parameters
gateway-address
Default
The default is None.
Command Mode
Privileged EXEC
4-15 serviceport ipv6 neighbor
This command is used for the manual addition of IPv6 neighbors to the IPv6 neighbor table for the service
port. The entry is automatically converted to a static entry if an IPv6 neighbor already exists in the
neighbor table. Also, the neighbor discovery process does not result in static entries being modified. Such
entries are, however, treated in the same manner for IPv6 forwarding. Furthermore, when the
corresponding interface is operationally active, static IPv6 neighbor entries are applied to both the kernel
stack and to the hardware.
The no command is used for the removal of IPv6 neighbors from the IPv6 neighbor table for the service
port.
serviceport ipv6 neighbor ipv6-address macaddr
no serviceport ipv6 neighbor ipv6-address macaddr
Indicates the gateway address in the IPv6 global or link-local address
format.
28