D-Link 5000 Series Cli Reference Manual page 441

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
5-386 role priority
Configure VPC switch priority for VPC role election. The priority value is sent to the peer in the VPC
keepalive messages. A VPC switch with lowered priority is converted to the Primary while the switch with
the higher priority is converted as the Secondary.
No command resets the keepalive priority and timeout to default (100).
role priority 1-255
no role priority
Parameters
None
Default
The default is 100.
Command Mode
VPC Config
5-387 system-mac
Manually configure the MAC address for the VPC domain. The VPC MAC address should carry the same
configuration both peer devices.
The specified MAC address must be a unicast MAC address <aa:bb:cc:dd:ee:ff> format. The address
assigned must not use the primary VPC nor the secondary VPC device. The configured VPC MAC
address is exchanged during role election and if configured differently on the peer devices, VPC is not
initiated.
No command removes the manually configured VPC MAC address for the VPC domain.
system-mac mac-address
no system-mac
Parameters
mac-address
Default
The default is None.
Command Mode
VPC Domain
Enter MAC address.
435