D-Link DGS-1008D User Manual
8-port 10/100/1000mbps gigabit ethernet switch
Hide thumbs
Also See for DGS-1008D:
- User manual (32 pages) ,
- Quick installation manual (83 pages) ,
- Manual (20 pages)
Related Manuals for D-Link DGS-1008D
Summary of Contents for D-Link DGS-1008D
- Page 1 D-Link™ DGS-1008D 8-Port 10/100/1000Mbps Gigabit Ethernet Switch Manual Rev 3.00 Building Networks for People RECYCLABLE...
- Page 2 Microsoft Corporation. Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. D-Link Corporation disclaims any proprietary interest in trademarks and trade names other than its own.
-
Page 3: Table Of Contents
D-Link DGS -1008D Unmanaged Gigabit Ethernet Switch INTRODUCTION...1 ...1 THERNET ECHNOLOGY Fast Ethernet Technology ...1 Gigabit Ethernet Technology ...1 802.1P S...1 Advantages of QoS ...1 Understanding QoS ...2 ...2 WITCHING ECHNOLOGY WITCH ESCRIPTION ...3 Features ...3 ...3 RONT ANEL OMPONENTS LED Indicators...4... -
Page 4: Intended Readers
Glossary – Lists definitions for terms and acronyms used in this document. Intended Readers The DGS-1008D Manual contains information for setup and management, and of the DGS-1008D Switch. This manual is intended for network managers familiar with network management concepts and terminology. -
Page 5: Safety Instructions
To help avoid damaging your system, be sure the voltage selection switch (if provided) on the power supply is set to match the power available at your location: –... - Page 6 D-Link DGS -1008D Unmanaged Gigabit Ethernet Switch When connecting or disconnecting power to hot -pluggable power supplies, if offered with your system, observe the following guidelines: – Install the power supply before connecting the power cable to the power supply.
-
Page 7: Protecting Against Electrostatic Discharge
D-Link DGS -1008D Unmanaged Gigabit Ethernet Switch Protecting Against Electrostatic Discharge Static electricity can harm delicate components inside your system. To prevent static damage, discharge static electricity from your body before you touch any of the electronic components, such as the microprocessor. You c a n do so by periodically touching an unpainted metal surface on the chassis. -
Page 8: Introduction
802.1P and QoS The DGS-1008D Switch supports 802.1p priority queuing Quality of Service. The implementation of QoS (Quality of Service) and benefits of using 802.1p priority queuing are described here. -
Page 9: Understanding Qos
The picture above shows the default priority setting for the Switch. Class-3 has the highest priority of the four priority queues on the Switch. In order to implement QoS, the user is required to instruct the Switch to examine the header of a packet to see if it has the proper identifying tag tagged. -
Page 10: Switch Description
Switch Description The DGS -1008D Switch is equipped with five ports providing dedicat ed 10, 100, or 1000 Mbps bandwidth. These ports can be used for connecting PCs, printers, servers, routers, Switches, hubs, and other network devices. The five multi-speed ports use standard twisted pair cabling and are ideal for segmenting networks into small, connected subnets. -
Page 11: Led Indicators
LED indicators follows (see LED Indicators). The LED indicators of the Switch include Power, Link/Act, 1000Mbps, and 100Mbps. The Cable Diagnostic functions of the Switch are indicated by a combination of the Speed and the Link/Act LEDs, as described below. -
Page 12: Rear Panel Description
Power is supplied through an external AC power adapter. Check the technical specification section for information about the AC power input voltage. Figure 1-3. Rear panel view of the Switch 10/100/1000BASE-T Ports: Eight (8) Gigabit Ethernet, Auto-Negotiating ports (10/100/1000Mbps) Comprehensive LED indicators display the conditions of t he Switch and status of the network. -
Page 13: Installation
The site where you install the Switch may greatly affect its pe rformance. Please follow these guidelines for setting up the Switch. Install the Switch on a sturdy, level surface that can support at least 3 kg (6.6 lbs.) of weight. Do not place heavy objects on the Switch. -
Page 14: Mounting The Switch On A Wall
Attaching the Rubber Feet § Use the rubber feet provided. Position and apply the rubber feet to the underside of the DGS-1008D Switch. Figure 2 -2. Attaching the Rubber Feet Do not place any device on top of Switch, or place the Switch on top of any device... -
Page 15: Power On
D-Link DGS -1008D Unmanaged Gigabit Ethernet Switch Power On Plug one end of the AC to DC power converter into the power connector of the Switch and the other end into the local power source outlet. After the Switch is powered on, the LED indicators will momentarily blink. This blinking of the LED indicators represents a reset of the system. -
Page 16: Connecting The Switch
End nodes include PCs outfitted with a 10, 100, or 1000 Mbps RJ-45 Ethernet/Fast Ethernet Network Interface Card (NIC) and most routers. An end node can be connected to the Switch via a twisted-pair Category 3, 4, 5, or 5e UTP/STP cable. The end node can be connected to any of the ports of the Switch. -
Page 17: Connecting To Network Backbone Or Server
D-Link DGS -1008D Unmanaged Gigabit Ethernet Switch Figure 3-2. Switch connected to a port on a hub or switch using either a straight or crossover cable–any standard Ethernet cable is fine Connecting To Network Backbone or Server Any of the five Gigabit Ethernet ports are ideal for uplinking to a network backbone or network server. -
Page 18: Technical Specifications
D-Link DGS -1008D Unmanaged Gigabit Ethernet Switch Technical Specifications Standards: IEEE 802.3ab 1000BASE -T IEEE 802.3u 100BASE-TX IEEE 802.3 10BASE-T IEEE 802.3x Flow Control IEEE 802.1p priority Queues Protocol: CSMA/CD Data Transfer Ethernet: Rate: Fast Ethernet: Gigabit Ethernet: Topology: Star... - Page 19 D-Link DGS -1008D Unmanaged Gigabit Ethernet Switch Transmission Store-and-forward Method: RAM Buffer : 144KBytes per device Filtering Address 8K MAC address per device Table: Packet Filtering/ Full wire speed Forwarding Rate: MAC Address Self-learning, auto-aging Learning: Performance...
-
Page 20: Glossary
100BASE -TX – 100Mbps Ethernet implementation over Category 5 and Type 1 Twisted Pair cabling. 10BASE-T – The IEEE 802.3 specification for Ethernet over Unshielded Twisted Pair (UTP) cabling. aging – The automatic removal of dynamic entries from the Switch Database which have timed-out and are no longer valid. - Page 21 – A device that filters, forwards, and floods packets based on the packet’s destination address. The Switch learns the addresses associated with each switch port and builds tables based on this information to be used for the switching decision.
- Page 22 Any repair or replacement will be rendered by D -Link at an Authorized D-Link Service Office. The replacement hardware need not be new or have an identical make, model or part. D-Link may, at its option, replace the defective Hardware or any part thereof with any reconditioned product that D-Link reasonably determines is substantially equivalent (or superior) in all material respects to the defective Hardware.
- Page 23 Any hardware, software, firmware or other products or services provided by anyone other than D-Link; and Products that have been purchased from inventory clearance or liquidation sales or other sales in which D-Link, the sellers, or the liquidators expressly disclaim their warranty obligation pertaining to the product.
- Page 24 D-Link DGS -1008D Unmanaged Gigabit Ethernet Switch Register online your D-Link product at http://support.dlink.com/register/ Product registration is entirely voluntary and failure to complete or return this form will not diminish your warranty rights.
-
Page 25: International Offices
D-Link DGS -1008D Unmanaged Gigabit Ethernet Switch International Offices U.S.A 17595 Mt. Herrmann Street Fountain Valley, CA. 92708 TEL: 714-885-6000 Fax 866-743-4905 URL: www.dlink.com Canada 2180 Winston Park Drive Oakville, Ontario, L6H 5W1 Canada TEL: 1-905-8295033 FAX: 1-905-8295223 URL: www.dlink.ca Europe (U. -
Page 26: Registration Card
8. What category best describes your company? oAerospace oEngineering oEducation oFinance oHospital oLegal oInsurance/Real Estate oManufacturing oRetail/Chainstore/Wholesale oGovernment oTransportation/Utilities/Communication oVAR oSystem house/company oOther_________________________________________________________________________ 9. Would you recommend your D-Link product to a friend? oYes oNo oDon't know yet 10.Your comments on this product? _____________________________________________________________ ___________________________________________________________________________________________________________________________... - Page 27 D-Link DGS -1008D Unmanaged Gigabit Ethernet Switch...
- Page 28 D-Link DGS -1008D Unmanaged Gigabit Ethernet Switch...