Sfp Transceiver Commands - D-Link 5000 Series Cli Reference Manual

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
Parameters
dual-ipv4-and-ipv6 default
ipv4-routing
Default
The default is None.
Command Mode
Privileged EXEC
Example
The following is an output sample of a SDM template. The next active SDM template has not been
changed.
(Router)#show sdm prefer
The current template is the Dual IPv4 and IPv6 template.
ARP Entries...................................... 2560
IPv4 Unicast Routes.............................. 8160
IPv6 NDP Entries................................. 2560
IPv6 Unicast Routes.............................. 2048
ECMP Next Hops................................... 48
IPv4 Multicast Routes............................ 1536
IPv6 Multicast Routes............................ 512
Display Parameters
ARP Entries
IPv4 Unicast Routes
IPv6 NDP Entries
IPv6 Unicast Routes
ECMP Next Hops

SFP Transceiver Commands

Display SFP transceiver information. Transceivers that are compliant with the SFF-8472 (SFP+, SFP28)
and SFF-8436(QSFP+, QSFP28) standards are supported.
5-187 show fiber-ports optical-transceiver
(Optional) List the scaling parameters for the template supporting IPv4
and IPv6.
List template parameters for IPv4-only template.
The maximum number of entries in the IPv4 Address Resolution
Protocol (ARP) cache for routing interfaces.
The maximum number of IPv4 unicast forwarding table entries.
The maximum number of IPv6 Neighbor Discovery Protocol (NDP)
cache entries.
The maximum number of IPv6 unicast forwarding table entries.
The maximum number of next hops that can be installed in the IPv4 and
IPv6 unicast forwarding tables.
284