5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
Packets RX
Bytes TX
Bytes RX
Parameters
None
Default
The default is None.
Command Mode
Privileged EXEC
6-52
show nvgre
This command is used to show the configuration and status of one or more NVGRE VNs. It also shows
information regarding allowed limits and statistics
show nvgge [vsid]
Parameters
vsid
Default
The default is None.
Command Mode
Privileged EXEC
Example
(Routing)(ConFig)#show nvgre
NVGRE Admin Mode................................. Enable
Maximum Allowed Limits or Table Sizes
-------------------------------------------------------
Tenant Table Size................................ 1024
Access Ports Table Size.......................... 2048
Tunnel/Network Reference Ports Table Size........ 8192
Current Entries Count or Table Usage
-------------------------------------------------------
Tenant Table Entries............................. 1
Number of unicast packets received from the VTEP.
Number of unicast bytes sent to the VTEP.
Number of unicast bytes received from the VTEP.
(Optional) Indicates a NVGRE VSID (1-16777214).
619