D-Link 5000 Series Cli Reference Manual page 971

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
Expiry Time (hh:mm:ss)
DR Priority
9-40 show ip pim bsr-router
Shows the bootstrap router (BSR) information.
show ip pim bsr-router {candidate | elected}
Parameters
candidate
elected
Default
The default is None.
Command Mode
•
Privileged EXEC
•
User EXEC
Example
The following is an example of the CLI display output for the command.
(Routing)#show ip pim bsr-router elected
BSR Address...................................... 192.168.10.1
BSR Priority ............................... 0
BSR Hash Mask Length ....................... 30
Next Bootstrap message (hh:mm:ss ........... 00:00:24
(Routing)#show ip pim bsr-router candidate
BSR Address...................................... 192.168.10.1
BSR Priority ............................... 0
BSR Hash Mask Length ....................... 30
C-BSR Advertisement Interval (secs) ........ 60
Next Bootstrap message (hh:mm:ss) .......... NA
The following message will be displayed if no selected or configured BSRs exist on the router:
No BSR's exist/learned on this router.
Time remaining for the neighbor to expire.
The DR Priority configured on this Interface (PIM-SM only).
Note: DR Priority is applicable only when sparse-mode configured
routers are neighbors. Otherwise, NA is displayed in this field.
Indicates a PIM BSR Candidate table information.
Indicates a PIM BSR Elected table information.
965