D-Link 5000 Series Cli Reference Manual page 624

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
tenant-system mac-addr
Default
The default is None.
Command Mode
Global Config
6-50 clear counters nvgre
This command is used to clear the packet and byte counters for all of the configured NVGRE virtual
networks.
clear counters nvgre
The command causes the following counter information to be cleared for all configured NVGRE NVEs:
Packets TX
Packets RX
Bytes TX
Bytes RX
Parameters
None
Default
The default is None.
Command Mode
Privileged EXEC
6-51 clear counters vxlan
This command is used to clear the packet and byte counters for all of the configured VXLAN virtual
networks.
clear counters vxlan
The command causes the following counter information to be cleared for all configured VXLAN VTEPs:
Packets TX
Indicates the MAC address for the tenant system configuration.
Number of unicast packets sent to the NVE.
Number of unicast packets received from the NVE.
Number of unicast bytes sent to the NVE.
Number of unicast bytes received from the NVE.
Number of unicast packets sent to the VTEP.
618