D-Link 5000 Series Cli Reference Manual page 758

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
Enable global passive mode by default for all interfaces. It overrides any interface level passive mode.
OSPF will not form adjacencies over a passive interface.
No command disables the global passive mode by default for all interfaces. Any interface previously
configured to be passive reverts to non-passive mode.
passive-interface default
no passive-interface default
Parameters
None
Default
The default is Disabled.
Command Mode
Router OSPF Config
7-159 passive-interface (OSPF)
Set the interface as passive. It overrides the global passive mode that is currently effective on the
interface.
No command sets the interface as non-passive. It overrides the global passive mode that is currently
effective on the interface.
passive-interface {slot/port | vlan vlan-id}
no passive-interface {slot/port | vlan vlan-id}
Parameters
slot/port
vlan vlan-id
Default
The default is Disabled.
Command Mode
Router OSPF Config
7-160 timers pacing flood
Enter an interface in slot/port format.
Enter an interface in VLAN format.
752