D-Link 5000 Series Cli Reference Manual page 115

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
Default
The default is Disabled.
Command Mode
Privileged EXEC
4-126 radius server attribute 4
This command is used to specify the RADIUS client that will use the NAS-IP-Address attribute in the
event of RADIUS requests. If a given IP address is specified when this attribute is enabled, the RADIUS
client will use that IP address when sending the NAS-IP-Address attribute in RADIUS communications.
The no command is used to disable the NAS-IP-Address attribute global parameter for RADIUS clients.
The RADIUS client will not send the NAS-IP-Address attribute along with RADIUS requests when this
parameter is disabled.
radius server attribute 4 [ipaddr]
no radius server attribute 4 [ipaddr]
Parameters
4
ipaddr
Default
The default is None.
Command Mode
Global Config
Example
The following provides an example of the command.
(Routing)(Config)#radius server attribute 4 192.168.37.60
(Routing)(Config)#
4-127 radius server host
This command is used to configure the IP address or DNS name that is to be used when communicating
with the RADIUS server for the selected server type. When configuring the DNS name or IP address for
authenticating or accounting servers, the user can also configure the server name and port number. In
the event that the no names are indicating when configuring the authenticating and accounting servers,
the command will use DefauIt_RADIUS_Auth_Server and Default_RADlUS_Acct_Server, respectively, as
the default names. The same name can be used in configuring more than one authenticating server,
whereas the names used for accounting servers should be unique. The configuration of a maximum of 32
authenticating and accounting servers are allowed by the RADIUS client.
NAS-IP-Address attribute to be used in RADIUS requests.
(Optional) The IP address of the server.
109