D-Link 5000 Series Cli Reference Manual page 612

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
IP Mode
Static IP Address
OpenFlow Variant
Default Table
Passive Mode
6-38 show openflow configured controller
This command is used to display a list of the configured OpenFlow Controllers. Only when the OpenFlow
variant is 1.0 or 1.3 will the switch communicate with these controllers.
show openflow configured controller
Parameters
None
Default
The default is None.
Command Mode
Privileged EXEC
Example
The following is an example of the CLI display output for the command.
(Routing)#show openflow configured controller
IP Address IP Port
--------------- ----------
172.21.4.217 6633
Display Parameters
IP Address
IP Port
Connection Mode
Role
then the status is None.
lP mode assigned by the command. The lP mode can be Auto, Static,
or ServicePort IP.
Static IP address assigned by the command.
OpenFlow Protocol Variant. The OpenFlow protocol can be OpenFlow
1.0 or OpenFlow 1.3.
The Hardware Table used as the target for flows installed by an
OpenFlow 1.0 controller which is not enhanced to handle multiple
hardware tables.
The OpenFlow passive mode set by the command.
Connection Mode
---------------
SSL
IPv4 address of the controller.
IPv4 port number for the controller connection.
SSL or TCP Controller Connection mode.
The role of the controller: Master, Equal, Slave.
606
Role
----------
Master