D-Link 5000 Series Cli Reference Manual page 847

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
Parameters
None
Default
The default is None.
Command Mode
Privileged EXEC
Example
The following provides an example of the command.
(1b6m)#show route preferences
Local............................................ 0
Static........................................... 1
OSPF Intra....................................... 110
OSPF Inter....................................... 110
OSPF External.................................... 110
BGP External..................................... 20
BGP Internal..................................... 200
BGP Local........................................ 200
Display Parameters
Local
Static
OSPF lntra
OSPF Inter
OSPF External
BGP External
BGP Internal
BGP Local
8-49 show ipv6 route summary
Shows a summary of the routing table's current status. If the optional all keyword is used, then some
statistics, such as the number of routes from each source, will also include counts for alternate routes. An
alternate route consists of a route that is not the most preferred route to its own destination, such that it is
not installed in the forwarding table. To be shown only the number of best routes, omit the optional
keyword.
show ipv6 route summary [all]
Preference of directly-connected routes.
Preference of static routes.
Preference of routes within the OSPF area.
Preference of routes to other OSPF routes that are outside of the area.
Preference of OSPF external routes.
Preferepce of BGP external routes.
Preference of routes to other BGP routes that are outside of the area.
Preference of routes within the BGP area.
841