Dhcp And Bootp Relay Commands - D-Link 5000 Series Cli Reference Manual

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
Example
The following is an example of the CLI display output for the command.
(Router)#show ip vrrp interface brief
Interface
----------
Vlan6
Vlan10
Vlan60
Vlan808
Vlan200
Vlan201
Display Parameters
Interface
VRID
IP Address
Mode
State

DHCP and BOOTP Relay Commands

This section describes the commands you use to configure BootP/DHCP Relay on the switch. A DHCP
relay agent operates at Layer 3 and forwards DHCP requests and replies between clients and servers
when they are not on the same physical subnet.
7-108 bootpdhcprelay cidoptmode
Enable the circuit ID option mode for BootP/DHCP Relay on the system.
No command disables the circuit ID option mode for BootP/DHCP Relay on the system.
bootpdhcprelay cidoptmode
no bootpdhcprelay cidoptmode
Parameters
None
Default
The default is Disabled.
VRID IP Address
----- ---------------
6 192.168.16.1
10 192.168.20.1
60 192.168.2.1
8 100.65.251.150
200 192.168.40.1
201 192.168.41.1
slot/port
Router lD of the virtual router.
Virtual router IP address.
Indicates whether the virtual router is enabled or disabled.
State (Master/Backup) of the virtual router.
Mode State
---------- ----------
Enable Master
Enable Master
Enable Master
Enable Master
Enable Master
Enable Master
720