Double Vlan Commands - D-Link 5000 Series Cli Reference Manual

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
Intf PVID Ingress
----- ----- ---------
0/1 1
0/2 1

Double VLAN Commands

This section describes double VLAN (DVLAN) configuration. Double VLAN tagging uses a Metro Core to
allow VLAN traffic from one customer domain to another.
5-275 dvlan-tunnel ethertype (Interface Config)
Configure the Ethertype for a specified interface. A two-byte hex ethertype is used to define the first 16
bits of the DVLAN tag. The Ethertype supports the following values 802.1Q, vman, or custom. lf the
Ethertype with custom value must be set to a value range of 1 to 65535.
No command disassociates globally defined TPID(s) to its relevant interface.
dvlan-tunnel ethertype {802.1Q | vman | custom 1-65535}
no dvlan-tunnel ethertype {802.1Q | vman | custom 1-65535}
Parameters
802.1Q
vman
custom 1-65535
Default
The default is VMAN.
Command Mode
Interface Config
5-276 dvlan-tunnel ethertype primary-tpid
Create a TPID and associate it with the next available TPID register. A TPID registers slot must be
available, otherwise the system returns an error to the user. The command [default-tpid] forces the TPID
value as the default TPID at index 0.
No command resets the TPID register to 0. Initialization resets all TPID registers to default.
dvlan-tunnel ethertype {802.1Q | vman | custom 1-65535} [primary-tpid]
no dvlan-tunnel ethertype {802.1Q | vman | custom 1-65535} [primary-tpid]
Acceptable
Filtering Frame Type
----------
Enabled Admit All
Disabled Admit All
Configure the Ethertype as 0x8100.
Commonly used value: 0x88A8.
Custom value range: 1 to 65535.
Untagged Tagged
Vlans Vlans
-------- --------
1,4-7 30-40,55
1 30-40,55
357
Forbidden Dynamic
Vlans Vlans
-------- --------
3,100-200 88,96
none none