D-Link 5000 Series Cli Reference Manual page 558

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
5-556 dos-control tcpport
This command enables TCP L4 source = destination port number (Source TCP Port = Destination TCP
Port) Denial of Service protection. If the mode is enabled, Denial of Service prevention is active for this
type of attack. If packets ingress with Source TCP Port = Destination TCP Port, the packets will be
dropped if the mode is enabled.
Use the no command to disable TCP L4 source = destination port number (Source TCP Port =
Destination TCP Port) Denial of Service protection.
dos-control tcpport
no dos-control tcpport
Parameters
None
Default
The default is Disabled.
Command Mode
Global Config
5-557 dos-control udpport
This command enables UDP L4 source = destination port number (Source UDP Port = Destination UDP
Port) DoS protection. If the mode is enabled, Denial of Service prevention is active for this type of attack.
If packets ingress with Source UDP Port = Destination UDP Port, the packets will be dropped if the mode
is enabled.
Use the no command to disable UDP L4 source = destination port number (Source UDP Port =
Destination UDP Port) Denial of Service protection.
dos-control udpport
no dos-control udpport
Parameters
None
Default
The default is Disabled.
Command Mode
Global Config
552