D-Link 5000 Series Cli Reference Manual page 169

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
rising interval
falling threshold
falling interval
5-27 show process app-list
This command is used to show the user and system applications.
show process app-list
Parameters
None
Default
The default is None.
Command Mode
Privileged EXEC
Example
The following is an example of the CLI display output for the command.
(Routing)#show process app-list
ID Name
--- ----------
1 dataplane
2 switchdrvr
3 syncdb
4 lighttpd
5 syncdb-test
6 proctest
7 user.start
Indicates, the duration, in seconds, for the CPU rising threshold violation
that must be met to trigger a notification (range: 5 to 86400; default: 0
(disabled)).
Indicates the percentage of CPU resources that triggers a notification
when exceeded by the configured falling interval (range: 1 to 100;
default: 0 (disabled)).In other words, when the total CPU utilization falls
below the specified level for a configured period of time, a notification is
triggered. Note that the falling utilization threshold notification is
triggered only if a rising threshold notification was previously sent. The
falling utilization threshold value must always be set at equal to or less
than the rising threshold value.
Indicates, the duration, in seconds, for the CPU falling threshold
violation that must be met to trigger a notification (range: 5 to 86400;
default: 0 (disabled)).
PID Admin Status
------- ------------
15309 Enabled
15310 Enabled
15314 Enabled
18718 Enabled
0 Disabled
0 Disabled
0 Enabled
163
Auto Restart Running Status
------------ ---------------
Disabled Running
Disabled Running
Disabled Running
Enabled Running
Disabled Stopped
Enabled Stopped
Disabled Stopped