Dgs-1210-10; Front Panel - D-Link DGS-1210 Series Manual

1 Product Introduction
the switches with other third-party devices for management in an SNMP-enabled environment. D-Link Smart
Managed Switches provides easy-to-use graphic interface and facilitates the operation efficiency.

DGS-1210-10

8-Port 10/100/1000Mbps plus 2 SFP ports (100/1000Mbps) Smart Managed Switch.

Front Panel

The front panel of the DGS-1210-10 switch consists out of the following:
• Power LED : The Power LED lights up when the Switch is connected to a power source.
Port Link/Act/Speed LED (1-8): The Link/Act/Speed LED flashes, which indicates a network link
•
through the corresponding port. Blinking indicates that the Switch is either sending or receiving data to
the port. When a port has an amber light, this indicates that the port is running on 10M or 100M. When
it has a green light it is running on 1000M.
• Port Link/Act/Speed LED (9F, 10F): The Link/Act/Speed LED flashes, which indicates a network link
through the corresponding port. Blinking indicates that the Switch is either sending or receiving data to
the port. When the port LED glows in amber, it indicates the port is running on 100M. When the port
LED glows in green, it is running on 1000Mbps.
Reset: Press the Reset button for 1~5 seconds to reboot the device. Press the Reset button for 6~10
•
seconds to reset the Switch back to the default settings and led will be solid light with amber for 2
seconds. Or press the Reset button over 11 seconds to enter the loader mode after device reboot and
the led will be solid light with green for 2 seconds. If the device cannot reboot the Switch via image 1
and image 2, the device will enter the loader mode automatically.
Figure 1.1 – DGS-1210-10 Front Panel
CAUTION: This product is intended to be use with a UL Listed
Optical Transceiver product, Rated DC3.3V, Laser Class I.
ATTENTION: Ce produit est destiné à être utilisé avec un
transceiveur optique homologué UL,tension DC3.3V, classe laser
I.
CAUTION: The equipment power supply cord shall be connected
to a socket-outlet with earthing connection.
ATTENTION: Le cordon d'alimentation de l'équipement doit être
branché sur une prise de courant dotée d'une connexion à la terre.
NOTE: Once user enter in loader mode, please use DNA tool
(standalone version 2.0.2.4 only (No support by Chrome
DNA3.x.x.x)) to download the image for recovery, or call D-Link
Technical Support for further assistance.
D-Link Smart Managed Switch User Manual
3
3