Router Discovery Protocol Commands - D-Link 5000 Series Cli Reference Manual

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
Default
The default is None.
Command Mode
Privileged EXEC
Example
The following shows an example of the command.
(Routing)#clear ip prefix-list orange 20.0.0.0/8
7-77 clear ipv6 prefix-list
Reset and clear IPv6 prefix-list hit counters. The hit count is a value indicating the number of matches to
a specific prefix list entry.
clear ipv6 prefix-list [prefix-list-name] [ipv6-prefix/prefix-length]
Parameters
prefix-list-name
ipv6-prefix/prefix-length
Default
The default is None.
Command Mode
Privileged EXEC

Router Discovery Protocol Commands

This section describes the commands you use to view and configure Router Discovery Protocol settings
on the switch. The Router Discovery Protocol enables a host to discover the lP address of routers on the
subnet.
7-78 ip irdp
Enable Internet Router Discovery Protocol (IRDP) on an interface or range of interfaces.
No command disables Router Discovery on an interface.
(Optional) Name of the prefix list from which the hit count is to be
cleared.
(Optional) IPv6 prefix number and length (in bits) of the network mask. If
this option is specified, hit counters are only cleared for the matching
statement.
697