D-Link 5000 Series Cli Reference Manual page 738

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
Parameters
ip-address
wildcard-mask
area-id
Default
The default is Disabled.
Command Mode
Router OSPF Config
7-121 1583compatibility
Enable OSPF 1583 compatibility.
No command disables OSPF 1583 compatibility.
Note: 1583 compatibility mode is enabled by default. If all OSPF routers in the routing domain are
capable of operating according to RFC 2328, OSPF 1583 compatibility mode should be disabled.
1583compatibility
no 1583compatibility
Parameters
None
Default
The default is Enabled.
Command Mode
Router OSPF Config
7-122 area default-cost (OSPF)
Configure the default cost for the stub area. You must specify the area ID and an integer value from 1 to
16777215.
area areaid default-cost 1-16777215
Parameters
areaid
Enter an IP Address.
IP-address-type mask that includes "don't-care bits".
Identifies the OSPF Router Area identification.
Indicates an area ID.
732