D-Link 5000 Series Cli Reference Manual page 511

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
Parameters
vlanid
Default
The default is Disable.
Command Mode
•
lnterface Config
•
VLAN Mode
5-490 set mld groupmembership-interval
Use this command to set the MLD Group Membership Interval time on a VLAN, one interface or all
interfaces. The Group Membership Interval time is the amount of time in seconds that a switch waits for a
report from a particular group on a particular interface before deleting the interface from the entry. This
value must be greater than the MLDv2 Maximum Response time value. The range is 2 to 3600 seconds.
Use the no command to set the MLDv2 Group Membership Interval time to the default value.
set mld groupmembership-interval vlanid 2-3600
no set mld groupmembership-interval
Parameters
vlanid
Default
The default is 260.
Command Mode
•
Global Config
•
Interface Config
•
VLAN Mode
5-491 set mld maxresponse
Use this command to set the MLD Maximum Response time for the system, on a particular interface or
VLAN. The Maximum Response time is the amount of time in seconds that a switch will wait after sending
a query on an interface because it did not receive a report for a particular group in that interface. This
value must be less than the MLD Query Interval time value. The range is 1 to 65 seconds.
Use the no command to set the max response time (on the interface or VLAN) to the default value.
set mld maxresponse 1-65
Display MLD VLAN information
Display MLD group membership VLAN information
505