D-Link 5000 Series Cli Reference Manual page 28

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
Command Mode
Privileged EXEC
Usage Guideline
There is no support for the no form of the command serviceport protocol dhcp client-id. To remove the
client-id option from the DHCP client messages, issue the command serviceport protocol dhcp without
the client-id option. The command serviceport protocol none can be used to disable the DHCP client
and client- id option on the interface.
Example
The following shows an example command.
(Routing) # serviceport protocol dhcp client-id
4-6 network parms
This command is used to set the IP address, subnet mask, and gateway of the device. It is required that
the IP address and the gateway be located on the same subnet. The none option can be specified in
order to clear the IPv4 address and mask, as well as the default gateway (i.e., each of the values will be
reset to the default value on the switch).
network parms {ipaddr netmask [gateway] I none)}
Parameters
ipaddr
netmask
gateway
Default
The default is None.
Command Mode
Privileged EXEC
4-7 network protocol
This command is used to specify the network configuration protocol to be utilized. If the user modifies this
value, the change becomes effective immediately. If the bootp parameter is used, the switch sends
requests to a BOOTP server on a periodic basis until a response is received. If the DHCP parameter is
used, the switch sends requests to a DHCP server on a periodic basis until a response is received. If the
none parameter is used, the network information for the switch must be configured manually.
network protocol {none | bootp | dhcp}
Enter the summary address designated for a range of addresses here.
Enter the IP subnet mask used for the summary route here.
(Optional) Enter the gateway address used for the summary route here.
22