5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
6-33
openflow ip-mode
This command is used to direct the OpenFlow feature to use the configured IP address. If this command
is issued when the OpenFlow feature is already enabled, it will cause the feature to become disabled and
then re-enabled with the new IP address.
The no command is used to direct the OpenFlow feature to assign the IP address to itself automatically.
openflow ip-mode {auto | static | serviceport}
no openflow ip-mode
Parameters
auto
static
serviceport
Default
The default is Disabled.
Command Mode
Global Config
6-34
openflow passive-mode
This command is used to enable the OpenFlow passive-mode.
No command disables the OpenFlow passive-mode.
openflow passive-mode
no openflow passive-mode
Parameters
None
Default
The default is Disabled.
Command Mode
Global Config
Use network IP address.
Use static IP address.
Use serviceport IP address.
603