D-Link 5000 Series Cli Reference Manual page 596

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
6-18 show qcn interface
The show qcn interface command is used in the Privileged EXEC mode to show the Congestion Point
information for the port specified.
show qcn interface slot/port [cp-index cp-index]
Parameters
slot/port
cp-index cp-index
Default
The default is None.
Command Mode
Privileged EXEC
Example
The following is an example of the CLI display output for the command.
(Routing) #show qcn interface 0/1 cp-index 1
Interface 0/1
cp-index 1
MAC-Address 00:10:18:00:00:FF
CP-Identifier : 00012610071005
CNM-transmit-Priority
Congestion queue weight
Sample-base
Cp-Sizesetpoint
Min—HeaderOctets
Note: CPID can be deciphered as mentioned below
000126 : Last 3 bytes of system MAC Address
1 - unit number on which congestion is detected
0 - slot number on which congestion is detected
07 - port number on which congestion is detected
1 - unit number from which CNM is transmitted
0 - slot number from which CNM is transmitted
05 - port number on which CNM is transmitted
6-19 show qcn statistics
Indicates the slot/port interface.
(Optional) Enter the congestion point index
0
590