D-Link 5000 Series Cli Reference Manual page 132

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
Parameters
None
Default
The default is None.
Command Mode
Global Config
Example
The following provides an example of the CLI command.
(Routing)(Config)#tacacs-server keystring
Enter tacacs key: ********
Re-enter tacacs key: ********
4-150 tacacs-server source-interface
This command is used in the Global Configuration mode to configure the source interface (that is, the
source IP address) for TACACS+ server configuration. The address configured as the source-interface IP
address will be used to fill the IP header of management protocol packets. This in turn allows security
devices (such as firewalls) to identify the source packets sent by the specific switch.
If no source-interface is specified, the primary IP address for the outbound (originating) interface will be
used as the source address.
The no command is used to remove the global source interface (that is, the selected source IP) for all
TACACS+ communications between the server and the TACACS+ client.
tacacs-server source-interface {slot/port | loopback loopback-id | vlan vlan-id | network |
serviceport }
no tacacs-server source-interface
Parameters
slot/port
loopback loopback-id
vlan vlan-id
network
serviceport
Default
The default is None.
Indicates the specific port that will be used as the source interface.
Indicates the specific Ioopback interface that will be used as the source
interface (range for loopback ID: 0 to 7).
Indicates the specific VLAN that will be used as the source interface.
Indicates the network access client.
Indicates the serviceport interface ot use as the source interface.
126