Provisioning (Ieee 802.1P) Commands - D-Link 5000 Series Cli Reference Manual

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
Mode
EtherType

Provisioning (IEEE 802.1p) Commands

This section describes provisioning (IEEE 802.1p,) configuration for port prioritization.
5-279 vlan port priority all
Configure the port priority for untagged packets for all available ports; The priority range is 0-7.
vlan port priority all priority
Parameters
priority
Default
The default is 0.
Command Mode
Global Config
5-280 vlan priority
Configures default 802.1p port priority assignments for untagged packets for a specified interface. Priority
range is 0-7.
vlan priority priority
Parameters
priority
Default
The default is 0.
Enable or disable the mode, default: disabled.
The first 16 bits of the DVLAN tunnel are defined by a 2-byte
hexEtherType.
Three different EtherType tags are available: 802.1Q, which represents
the commonly used value of 0x8100; vMAN representing the commonly
used value of 0x88A8; Custom representing a custom tunnel value with
a range of 1 to 65535.
Enter a priority value (0-7) for untagged frames received.
Enter a priority value (0-7) for untagged frames received.
360