Table of Contents
Advertisement
fr lmi n391dte
Syntax
fr lmi n391dte n391-value
undo fr lmi n391dte
View
Interface view
Default level
2: System level
Parameters
n391-value: Value of counter N391, which ranges from 1 to 255.
Description
Use the fr lmi n391dte command to configure the full status polling interval at the DTE side.
Use the undo fr lmi n391dte command to restore the default.
By default, the full status polling interval is 6.
The DTE sends a Status-Enquiry message at a regular interval set by T391 to the DCE. Status-Enquiry
messages fall into the following types: link integrity verification messages and full link status enquiry
messages. N391 defines that the ratio of sent link integrity verification messages to sent full link status
enquiry messages is (N391–1):1.
Examples
# Set DTE as the operating mode of frame relay interface Serial 4/1/8:10, and the counter value of the
PVC status to 10.
<Sysname> system-view
[Sysname] interface Serial 4/1/8:10
[Sysname-Serial4/1/8:10] link-protocol fr
[Sysname-Serial4/1/8:10] fr interface-type dte
[Sysname-Serial4/1/8:10] fr lmi n391dte 10
fr lmi n392dce
Syntax
fr lmi n392dce n392-value
undo fr lmi n392dce
View
Interface view
Default level
2: System level
Parameters
n392-value: The Error threshold, which ranges from 1 to 10.
73
Advertisement
Table of Contents
