Setting A Time Limit For Videoconferences - Avaya Scopia XT Series Deployment Manual

Advanced Configuration of the XT Series
Field Name
Use manual DualVideo
bandwidth
DualVideo/Live bandwidth
ISDN > Rate (K)
3. From the web interface only, select Save.
4. Access the bandwidth limits for each network port. From the XT Series web interface,
select Administrator Settings > Networks > GLAN1/GLAN2 > Bandwidth. From the
endpoint's main menu, select Configure > Advanced > Networks > GLAN1/GLAN2 >
Bandwidth.
5. Set the fields as described in the following table:
Table 41: Configuring bandwidth settings of a call
Field Name
Enable
Max. Bandwidth Rx (KB)
Max. Bandwidth Tx (KB)
Related links
Advanced Configuration of the XT Series

Setting a Time Limit for Videoconferences

About this task
Set a time limit for videoconferences to alert users that the time allocated for the meeting is about
to end, and to end videoconferences that were left open.
December 2017
Description
If set to Yes allows to change bandwidth used for H.264 content
and live video (DualVideo/Live bandwidth).
Sets more bandwidth on Live Video or H.264 Content.
Sets the maximum call rate that the system uses for any ISDN
call.
Figure 90: Setting bandwidth limits for each network port
Description
Select Yes to enable limiting bandwidth for this network port.
Enter the incoming bandwidth limit for traffic on this network port,
measured in kilobytes (not kilobits) per second (KBps).
Enter the outgoing bandwidth limit for traffic on this network port.
on page 121
Avaya Video Collaboration Solution for IP Office Deployment Guide
Comments on this document? infodev@avaya.com
140