Configuring Multi-Stream Switching (Mss) Video - Avaya Scopia XT Series Deployment Manual

- Outgoing call are forwarded to the Equinox Meeting if the XT Series can add
calls.
- Two XT Series configured as a primary (Master) MCU cannot connect.
- The primary role, if active, is visible on the XT Series Web homepage.
Next steps
Restore the default MCU Role configuration after your meeting.
Related links
Advanced Configuration of the XT Series

Configuring Multi-Stream Switching (MSS) video

About this task
The Multi-Stream Switching (MSS) video solution uses the advanced switched video capabilities in
®
the Avaya Aura Media Server (AMS) to distribute multiple video streams to each MSS aware
participant. The following clients and components support MSS:
• XT Series endpoints
• Avaya Equinox
®
• Avaya Aura
®
• Avaya Aura
• Avaya Equinox Management
MSS is only supported for SIP calls.
You cannot enable MSS on XT Series devices with a CPU lower than 2.0.
Endpoints which do not support MSS receive active speaker's video from a video-enabled MSS
conference call. The received resolution could be low.
Only web collaboration is supported in this meeting type, so assure that it is enabled in the XT
Series.
Procedure
1. Access the MSS settings. From the XT Series web interface, select Administrator
Settings > Calls > Preferences > MSS. From the endpoint's main menu, select
Configure > Advanced > Calls > Preferences > MSS.
2. Configure the settings, as described in
December 2017
®
clients
components
Media Server
Avaya Video Collaboration Solution for IP Office Deployment Guide
Comments on this document? infodev@avaya.com
Configuring Multi-Stream Switching (MSS) video
on page 121
Table 59: MSS Settings on page 194.
193