Registering The Xt Series To Ip Office - Avaya Scopia XT Series Deployment Manual

Deploying the XT Series as a Server Only
4. Log in as described in
Important:
The initial IP assigned to the XT Series is a dynamic IP address. When you first
configure the system, assign a static IP address as described in
IP Address Settings
Related links
Deploying the XT Series as a Server Only

Registering the XT Series to IP Office

About this task
This section explains how to register your XT Series to the IP Office SIP server. If you do not
register to IP Office, you cannot host videoconferences on the built-in MCU.
The XT Series can function in a SIP environment, where names and numbers are managed by
SIP servers, not gatekeepers. You can dial an endpoint by entering its name or number like 1234
or joe_smith, rather than remembering its IP address, where the SIP server routes the call
correctly. To do this, the SIP server must register all endpoints to maintain the mapping list of
names/numbers and endpoints to successfully route calls.
For more information about deploying and configuring XT Series with IP Office, see IP Office
Video Collaboration Solution - Installation Notes.
Before you begin
Verify that you have the following information about your SIP environment:
• The DNS name or IP address of the Avaya IP Office server.
• The transport port used in your SIP environment.
• Credentials for authenticating XT Series to the Avaya IP Office server.
If configuring from the endpoint, you must first enable advanced configuration, as described in
Enabling Advanced Maintenance on the XT Series
Procedure
1. Access the SIP settings. From the XT Series web interface, select Administrator
Settings > Protocols > SIP. From the endpoint's main menu, select Configure >
Advanced > Protocols > SIP.
December 2017
Accessing XT Series Web Interface
on page 126.
on page 85
Avaya Video Collaboration Solution for IP Office Deployment Guide
Comments on this document? infodev@avaya.com
on page 71.
on page 122.
Configuring Advanced
88