Avaya Scopia XT Series Deployment Manual page 145

Field Name
Outputs > Analog Audio
Outputs > USB Headset
2. Assign inputs to their respective tracks. From the endpoint interface, select Yes to route an
input to Track 1 or Track 2. From the web interface, dragging it to Track 1 or Track 2 to
create the connection
interface on page 145).
To avoid echo or feedback loops, you cannot route room microphones to track 1, as this is
the default track for the main monitor's speakers (HD1). In addition, you can only route one
track for each audio output.
Figure 95: Drag an audio input to route it to a track on the web interface
Drag outputs in the same way from the right hand side to their respective tracks.
3. To remove the connection on the web interface, select the connection's x in the track box.
4. From the web interface only, select Save.
Related links
Advanced Configuration of the XT Series
December 2017
Description
Refers to an analog audio output device connected to the
Refers to the headphones of a USB headset connected to
the USB port. By default, a connected USB headset causes
HD1's output to be muted if Audio Outputs Management
is Automatic. To change this, set I/O connections > Audio
- Outputs > General > Audio Outputs Management to
Manual.
(Figure 95: Drag an audio input to route it to a track on the web
on page 121
Avaya Video Collaboration Solution for IP Office Deployment Guide
Comments on this document? infodev@avaya.com
Configuring Advanced Sound (Audio Output) Settings
port via its 3.5mm jack.
145