Sending Status With Snmp - Avaya Scopia XT Series Deployment Manual

Advanced Configuration of the XT Series
Field Name
Always initialized
Baud Rate
3. From the web interface only, select Save.
Related links
Advanced Configuration of the XT Series

Sending Status with SNMP

About this task
XT Series can work with SNMP servers to send traps or alarms on its status, and can send
information on its capabilities.
Before you begin
Ensure you have the IP addresses and the subnet mask of the computers which you want to use
for remote management of XT Series. In the case of Equinox Management, these fields are
automatically filled.
If configuring from the endpoint, you must first enable advanced configuration, as described in
Enabling Advanced Maintenance on the XT Series
Note:
Avaya does not consider SNMPv1 protocol to be secure and does not recommend it.
Procedure
1. Access the SNMP management settings. From the XT Series web interface, select
Administrator Settings > Utilities > Remote Access > SNMP. From the endpoint's main
menu, select Configure > Advanced > Utilities > Remote Access > SNMP.
December 2017
Description
Select Yes to avoid the need to accept an AT initialization
command before accepting other commands, when required by the
API. Use this when the controlling device cannot detect if the XT
Series restarted.
Set the rate to be the same as on the controlling device.
on page 121
Avaya Video Collaboration Solution for IP Office Deployment Guide
Comments on this document? infodev@avaya.com
on page 122.
176