Restoring Default User Settings - Avaya Scopia XT Series Deployment Manual

XT Mode
Upgrade done by:
An unsigned
package (lower
than 8.3)
Send the log file to your local customer support representative.
1. Remove the USB drive from the USB port of the Avaya Scopia
2. Connect the USB drive to a computer.
3. Locate the upgrade.log file on the flash drive.
4. Send the log file to your local customer service representative.
Related links
Troubleshooting the Avaya Scopia

Restoring Default User Settings

About this task
This procedure explains how to restore the default settings if necessary. You can do this from the
endpoint itself only.
Before you begin
If configuring from the endpoint, you must first enable advanced configuration, as described in
Enabling Advanced Maintenance on the XT Series
Procedure
1. From the endpoint's main menu, select Configure > Advanced > Utilities > Restore
System > Factory Defaults.
2. Confirm you want to remove all configurations.
The default settings are restored.
6
*By default, the unsigned software package is not accepted. You can force the system to accept an unsigned package
December 2017
Recovery Mode
PC/Management USB
XT <= 8.3.x: Accepted
XT >= 9.0: Not accepted
®
XT Series
Figure 183: Restoring factory default settings
by setting "Verify Signature" to No.
Avaya Video Collaboration Solution for IP Office Deployment Guide
Comments on this document? infodev@avaya.com
PC/Management
XT <= 8.3.x: Accepted
XT >= 9.0: Not accepted
on page 220
on page 122.
Restoring Default User Settings
Normal Mode
USB/AT/WEB
6
®
XT Series
251