Avaya Scopia XT Series Deployment Manual page 175

2. Set the fields as required.
Table 53: Configuring AT command settings
Field Name
AT commands
management
Enable all addresses
Address
Subnet mask
SSH Enabled
User Name
Password
December 2017
Figure 118: Configuring AT commands
Description
Select Yes to enable remote control AT commands API via both
TCP and serial cable. Select IP only to restrict it to a TCP
connection only, or RS232 serial port only to restrict AT control to
an RS232 serial cable connected to the USB port on the XT
Series.
Select No to disable remote control AT commands API via both
TCP and serial cable. If your deployment includes Equinox
Management, disabling this feature results in a failure to manage
the XT system.
Select No to restrict AT remote access via TCP to specific devices
with an IP address in the range of the Address and Subnet Mask
fields below.
Enter the IP address of control devices allowed to remotely control
the unit with AT commands.
Enter the Subnet mask to modify the Address field into a range of
addresses allowed to send the unit AT commands.
Select Yes to enable AT commands API via SSH.
The user name is set to atadmin and the default password is
1234. Avaya recommends that you change the default password.
Avaya Video Collaboration Solution for IP Office Deployment Guide
Comments on this document? infodev@avaya.com
Remotely Controlling the XT Series with AT Commands
Table continues...
175