Avaya Scopia XT Series Deployment Manual page 110

Initial Configuration of the XT Series
6. Enter the field values as described in
Table 26: Configuring the video layout
Field Name
Multi Image Mode
Multi Image Type
PIP - Position
PIP - Rotation
December 2017
Figure 68: Setting the video layout
Description
Enable PIP, PaP or PoP video layouts, depending on the number of video streams
available (see Figure 65: Single monitor video layouts with presentation
• <auto > enables PiP, PaP or PoP only when the number of video streams is greater
than the number of available monitors. The order of the video streams is set
automatically, with precedence to the presentation video streams.
• On always enables PiP, PaP or PoP when at least two video streams are used.
When you are using two monitors, PIP can be forced only if there are at least three
different video streams.
• Off always disables PIP, PaP and PoP.
Limit the video layouts available to users:
• auto enables PIP, PaP and PoP layouts. Press the Layouts
remote control or the Pip key on the advanced remote control, to switch between
PIP, PaP and PoP.
• PIP enables only PiP.
• PaP enables only PaP.
• PoP enables only PoP.
If you are using a 4K UHD or 2160p (3840x2160) monitor, Multi Image is set to PaP,
by default.
Set the position of the small overlapped image on the monitor: upper left, upper right,
lower left, or lower right.
Enables/disables image rotation and controls the direction in which the image rotates.
End-users press the Layouts
• Fixed blocks image rotation .
Avaya Video Collaboration Solution for IP Office Deployment Guide
Comments on this document? infodev@avaya.com
Table 26: Configuring the video layout
key to activate image rotation (if enabled).
on page 110.
on page 107).
key on the simplified
Table continues...
110