Avaya Scopia XT Series Deployment Manual page 67

Enter numbers or characters.
Press and hold
to toggle Do not disturb
Press to change multi-image type.
Hold to toggle Open layout page.
Enter letters and digits into a field using the remote's keypad on the XT Remote Control Unit. The
system displays the current entry method to the right of the field
displayed to the right of an input field
1/a/A button repeatedly while the cursor is in the input field, to switch between abc1 (default) for
lower case alphanumeric characters, ABC for upper case characters only (no digits), abc for just
lower case characters only (no digits), and 123 for digits only. To enter a letter or number, press a
key repeatedly to cycle through its characters.
December 2017
Hold to recall preset.
Open Contacts
Dial a call
Press to delete.
Hold to clear.
Toggle graphic
menu everywhere.
Volume
Press to toggle audio mute.
Hold to toggle privacy.
Change layouts
Press to select
far end
Press to select
near end
Figure 36: The XT Remote Control Unit (Advanced)
on page 68). You can switch entry methods by pressing the
Avaya Video Collaboration Solution for IP Office Deployment Guide
Comments on this document? infodev@avaya.com
About the XT Remote Control Unit
Standby or activate.
Press and hold to
switch off.
(Arrow keys)
Navigate menus.
Move camera.
Disconnect or
end a meeting
Press to select a menu item.
Long press to change input mode.
Back/undo.
Toggle graphic
menu on
home page.
Start/end
presentation
Press red and green keys
to activate programming mode.
Enter two digits to program.
Zoom
Press to toggle video mute.
Hold to toggle Do not disturb.
Help
Press to change input source.
Hold to toggle local/remote.
Press Memo then enter
two digits to position
near camera as preset.
Press Select then enter
two digits to select
saved near or far preset.
(Figure 37: Entry method
67