Avaya Scopia XT Series Deployment Manual page 139

Before you begin
If configuring from the endpoint, you must first enable advanced configuration, as described in
Enabling Advanced Maintenance on the XT Series
Procedure
1. Access the call settings. From the XT Series web interface, select Administrator
Settings > Calls > Preferences > General. From the endpoint's main menu, select
Configure > Advanced > Calls > Preferences > General.
2. Set the fields as described in the following table.
<auto > is the default setting. It indicates that the system tries to choose the settings that
best suit the local situation.
Table 40: Configuring bandwidth settings of a call
Field Name
IP > Rate (K)
Audio Coding
Video Coding
DualVideoCoding
December 2017
From the endpoint interface
Figure 89: Configuring general call settings
Description
Sets the maximum bitrate used for a single point-to-point call.
Sets the preferred audio codec that the system tries to send. The
remote system must support the same codec for a successful
connection.
Sets the preferred video codec that the system tries to send, if the
remote system supports the same codec.
H.239 or BFCP are not applicable to web collaboration.
Sets the resolution for H.264 content video.
Avaya Video Collaboration Solution for IP Office Deployment Guide
Comments on this document? infodev@avaya.com
Setting Call Bandwidth in XT Series
on page 122.
From the web interface
Table continues...
139