Avaya Scopia XT Series Deployment Manual page 114

Initial Configuration of the XT Series
5. Define the following settings for each camera connected to the XT Series
Table 28: Configuring advanced camera settings
Field Name
Enable
Presentation
Content
2
For the XT4300 (XT Flex Camera), there are additional settings, such as Ceiling Mount, IR Receivers, Picture, and Wide
Dynamic Range.
December 2017
From the endpoint interface
Figure 73: Configuring the camera settings from the web interface
Description
Select Yes to enable this camera. Otherwise, you cannot use the video
input from this camera. If you connected multiple cameras via the Avaya
®
Scopia XT Camera Switch, enable each camera.
You cannot disable the default camera.
(XT7100 only) Select Yes to use HD1 input for presentation content while
using HD2 for a live camera. If you use HD1 for the presentation content,
you can display a resolution up to 4K Full HD. In this scenario, you must
connect the first camera to the HD2 port of the XT Codec Unit and
connect the cable for serial control and power to the horizontal connect
(VISCA port). You must connect the computer displaying the presentation
to the HD1 port. An HDMI cable or adapter is needed. HD2 is
automatically configured for the default live camera and audio is disabled
for that port.
Avaya Video Collaboration Solution for IP Office Deployment Guide
Comments on this document? infodev@avaya.com
From the web interface
2
:
Table continues...
114