Saving Ptz Camera Positions - Avaya Scopia XT Series Deployment Manual

Saving PTZ Camera Positions

About this task
You can change your PTZ camera's position before or during a call and save that position for later
use as one of several presets. You can store up to 10 positions on the new XT Remote Control
Unit from the endpoint interface, or 122 more from the web interface or using the previous XT
Remote Control Unit.
You can also recall presets for remote cameras if they support FECC. Far End Camera Control
(FECC) is a feature of endpoint cameras, where the camera can be controlled remotely by another
endpoint in the call.
Procedure
1. To recall a position and move the camera quickly to a preset:
• From the new XT Remote Control Unit, press and hold the position number.
• From the previous XT Remote Control Unit, press Select then enter the position
number, up to two digits. * indicates 10, # indicates 11.
• From the XT Series web interface, select More Actions located just under the tabs,
then select Control Camera, and press Select on the row of the position number.
2. To save the camera to a new position, first move the camera and set its zoom.
• From the endpoint's main menu, select Control Camera (or from the In-Call menu,
during a call), and use the arrow and zoom keys to position the camera.
• From the XT Series web interface, select More Actions located just under the tabs,
then select Control Camera, and select the arrows and zoom icons to position the
camera.
December 2017
Figure 105: Recalling a camera preset with XT Remote Control Unit
Avaya Video Collaboration Solution for IP Office Deployment Guide
Comments on this document? infodev@avaya.com
Saving PTZ Camera Positions
163