Configuring Basic Network Settings - Avaya Scopia XT Series Deployment Manual

Initial Configuration of the XT Series

Configuring Basic Network Settings

About this task
This procedure describes how to set up the basic network settings and the IP address of the XT
Series as part of the Quick Setup Wizard. To modify advanced network settings, see
Advanced Network Settings
Procedure
1. Access the Quick Setup Wizard from the endpoint, as described in
Settings with the Quick Setup Wizard
2. Enter the following values:
Table 21: Configuring the IP address
Field Name
IP Address Mode or
Automatic IP Address
IP address
Subnet mask
December 2017
on page 125.
Figure 62: Defining IP Settings
Description
Determines if the IP address is dynamically allocated (using DHCP), or
if you manually designate a static IP address. You must use only static
addresses for:
• XT Telepresence deployments
• Units on a public network
• SIP deployments where the unit is secured with a TLS certificate, if
the certificate request has been tied to a specific IP address.
Enter the system static IP address. For dynamic IP addresses, this field
displays the current IP address.
Enter the subnet mask associated with the IP address. For dynamic IP
addresses, this field displays the current subnet mask.
Avaya Video Collaboration Solution for IP Office Deployment Guide
Comments on this document? infodev@avaya.com
on page 96, and skip to this step.
Configuring
Configuring Basic
Table continues...
100