Avaya Scopia XT Series Deployment Manual page 152

Advanced Configuration of the XT Series
upgrading and backing up of all endpoints in your video network. You can configure the XT Series
to use Equinox Management as the LDAP directory also from the Avaya Equinox Management
administrator portal (for details, see the Administrator Guide for Avaya Equinox Management).
Before you begin
If configuring from the endpoint, you must first enable advanced configuration, as described in
Enabling Advanced Maintenance on the XT Series
If you are using Avaya Equinox Management as the LDAP directory, you must associate LDAP
contacts to video endpoints; otherwise these contacts are not displayed on the XT Series. You
must also ensure that LDAP Contacts are enabled on your Equinox Management. Each LDAP
contact on the XT Series can only be mapped to a maximum of ten video endpoints.
Procedure
1. Access the LDAP settings. From the XT Series web interface, select Administrator
Settings > System > LDAP. From the endpoint's main menu, select Configure >
Advanced > System > LDAP.
From the endpoint interface
2. Select Add or Add Server.
December 2017
Figure 100: Configuring LDAP settings from the web interface
Avaya Video Collaboration Solution for IP Office Deployment Guide
Comments on this document? infodev@avaya.com
on page 122.
From the web interface
152