Avaya Scopia XT Series Deployment Manual page 164

Advanced Configuration of the XT Series
To position a remote camera with the XT Remote Control Unit, press near/far. To switch to
a different local camera, press ok/menu and select Video Source.
3. To store a new preset position:
• From the new XT Remote Control Unit, press ok/menu and select Presets, then press
the new position number (0-9).
• From the previous version of the XT Remote Control Unit, press the Presets > Memo
key, then press the new position number (0-99). To save positions 100-109, press * then
0-9. For 110-119, press # then 0-9.
• From the XT Series web interface, select select Store on the row of the new position
number.
4. To save your choice on the endpoint, press ok/menu.
The position number of the preset turns blue, indicating it was successfully stored.
Figure 107: Camera position stored successfully on the endpoint interface
On the web interface, the Assigned column now contains a check mark.
5. To delete a previously stored position with the XT Remote Control Unit, press its number
and then press the Delete
From the web interface, select Delete on the row of the position number.
December 2017
Figure 106: Storing a camera preset
key.
Avaya Video Collaboration Solution for IP Office Deployment Guide
Comments on this document? infodev@avaya.com
164