Setting The Default Camera Position - Avaya Scopia XT Series Deployment Manual

Related links
Advanced Configuration of the XT Series

Setting the Default Camera Position

About this task
You can make any of your preset positions the default position. Each time the system reboots, the
XT Remote Control Unit selects the default camera and positions the camera to the specified
preset.
Before you begin
Before you assign a camera position as the default, you must save a camera position, as
described in Saving PTZ Camera Positions
Procedure
1. From the XT Series web interface, select More Actions located just under the tabs, then
select Control Camera
2. Select a default camera by clicking the Select button associated with that camera.
Related links
Advanced Configuration of the XT Series
December 2017
on page 121
on page 163.
Figure 108: Control Camera
Figure 109: Setting Default
on page 121
Avaya Video Collaboration Solution for IP Office Deployment Guide
Comments on this document? infodev@avaya.com
Setting the Default Camera Position
165