Avaya Scopia XT Series Deployment Manual page 107

Before you begin
If configuring from the endpoint, you must first enable advanced configuration, as described in
Enabling Advanced Maintenance on the XT Series
Procedure
1. Access the monitor settings. From the XT Series web interface, select Administrator
settings > I/O connections > Monitor. From the endpoint's main menu, select
Configure > Advanced > I/O connections > Monitor.
2. Select General to access the general settings.
Figure 66: Configuring the general monitor settings from the web interface
3. Configure the general settings:
Table 25: Configuring general monitor settings
Field Description
Name
Number of
Activate the HDMI ports on the XT Codec Unit which connect to a monitor: the HD1
monitors
and/or the HD2
connect it to the HD1 port on the back panel. This monitor is only supported on the XT7000 Series
and is only supported as the main monitor.
December 2017
Figure 65: Single monitor video layouts with presentation
From the endpoint interface
port. If you are using a 4K UHD or 2160p (3840x2160) monitor, you must
Avaya Video Collaboration Solution for IP Office Deployment Guide
Comments on this document? infodev@avaya.com
on page 122.
From the web interface
Configuring Monitors
port
Table continues...
107