Connecting The Ptz Camera - Avaya Scopia XT Series Deployment Manual

Setting Up the XT Series Hardware

Connecting the PTZ Camera

About this task
This procedure describes how to connect the main PTZ camera to the Avaya Scopia
The XT7000 Series and the XT5000 Series use the XT Premium Camera or the Avaya Scopia
XT Deluxe Camera. The XT4300 uses the XT Flex Camera.
For details about the camera's capabilities, see
information about the room setup, see
Procedure
1. Place the camera in a position to ensure eye contact between local and remote
participants.
If the XT Codec Unit is housed in a cabinet, the XT Remote Control Unit sends the signal
to the infra-red receiver of the main camera to relay messages to the XT Codec Unit. In
this case, configure the camera settings so the camera's power is always on (see
Configuring Cameras
Try positioning the camera between the two monitors either directly above or below them,
at a distance which captures all the seats.
Caution:
Do not place the camera on top of the XT Codec Unit. It can cause the system to
overheat.
December 2017
Figure 14: Flex Camera
Figure 15: Deluxe Camera
Planning the Optimal Room Setup
on page 111).
Avaya Video Collaboration Solution for IP Office Deployment Guide
Comments on this document? infodev@avaya.com
Technical Specifications
®
XT Series.
®
on page 12. For more
on page 35.
42