December 2017 Avaya Video Collaboration Solution For Ip Office Deployment Guide - Avaya Scopia XT Series Deployment Manual

Deploying the XT Series as a Server Only
Parameter
UDP/TCP Listening Port
Transport Outbound BFCP
Use TLS
TLS Listening Port
Disable TLS 1.0/1.1
Verify Certificate
Certificate Hostname Validation
Verify Certificate Key Usage
December 2017 Avaya Video Collaboration Solution for IP Office Deployment Guide
Comments on this document? infodev@avaya.com
Description
Enter the same port number used by IP Office for
receiving inbound SIP calls. By default, the system uses
port 5060.
Select the transport protocol to use when sharing
content via BFCP, from the options listed below. BFCP
is a protocol which coordinates shared videoconference
features in SIP calls, often used by one participant at a
time.
• TCP Preferred: Select to use TCP. If the request fails,
the system tries again using UDP. The request might
fail, for example, if the receiving endpoint only accepts
incoming connections over UDP.
• UDP Preferred: Select to use UDP once. If the
request fails, the system tries again using TCP. The
request might fail, for example, if the receiving
endpoint only accepts incoming connections over
TCP.
• TCP Only: Select to only use TCP.
• UDP Only: Select to only use UDP.
Select Yes or No to enable or disable secure
transmission.
Enter the same port number used by IP Office for
receiving secure inbound SIP calls. By default, the
system uses port 5061.
Select to disable TLS 1.0/1.1.
Select Yes to connect to other devices via TLS only
when the other device has certificates signed by a CA
recognized by XT Series.
Select No to connect to a device whose certificate has
not been validated.
Select Accept Validated Only to ensure that only
certificates with validated hostnames are accepted by
XT Series. This is the default policy for certificate
hostname and key/extended key usage validation.
Select Accept Validated or same default certificate to
accept certificates which are validated or which are the
same as those currently used by the XT Series.
Select Accept All to accept certificates without
performing a hostname validation.
Select Yes to ensure that the XT Series only accepts
certificates if a 'Key Usage' or 'Extended Key Usage'
value is validated.
Table continues...
90