Avaya Scopia XT Series Deployment Manual page 80

Provisioning the XT Series
Field Name
8. Expand the Advanced Settings section, and configure the relevant options:
Table 15: Advanced Settings Options
Field Name
Visible in the directory of
other endpoints (H.350–
enabled endpoints, desktop
and mobile)
VIP Endpoint (experience will
not be downgraded during
call)
Has Embedded MCU
SIP Server 1
SIP Server 2
SIP Server 3
SIP Username
Authentication Name
Authentication Password
SIP Transport Type
Max Bandwidth
Default Call Bandwidth
(Kbps)
MTU Size
December 2017
Description
- Ask Confirmation
- Inform
- Show Status
When the Enable Encryption check box is not selected, the
Accepted Protected Calls option is enabled.
Description
Select to indicate that the endpoint is to appear in the directory
of H.350–enabled endpoints.
Select to assign the endpoint as a VIP endpoint without
diminishing call quality.
Select to indicate that the endpoint has an embedded MCU.
The first SIP server through which the endpoint registers for
calls. It may be Equinox Management.
The second SIP server through which the endpoint registers for
calls. The endpoint uses this server if SIP Server 1 is not
available.
The third SIP server through which the endpoint registers for
calls. The endpoint uses this server if SIP Server 1 and SIP
Server 2 are not available.
The username used to connect to the SIP server.
Enter a name used for authentication of the SIP server.
Enter the password used for authentication of the SIP server.
Select the protocol used by the SIP server:
• UDP
• TCP
• TLS
Select the maximum bandwidth of the endpoint.
Select the maximum bandwidth of the call managed by the
endpoint, measured in kilobytes per second (kbps).
The size of the maximum transmission unit, measured in bytes.
Avaya Video Collaboration Solution for IP Office Deployment Guide
Comments on this document? infodev@avaya.com
Table continues...
80