Avaya Scopia XT Series Deployment Manual page 135

Video Gateway, so it can route calls to a non-H.323 device. Registration with a gatekeeper may
happen every time the endpoint is switched on, or after a set period.
You can also secure your connection with the gatekeeper by enabling authentication. You can
enter a special username and password in both the endpoint and the gatekeeper as a shared
secret, which is used to authenticate the identities of the gatekeeper and endpoint.
Before you begin
If configuring from the endpoint, you must first enable advanced configuration, as described in
Enabling Advanced Maintenance on the XT Series
Procedure
1. Access the gatekeeper settings. From the XT Series web interface, select Administrator
Settings > Protocols > H.323 > General. From the endpoint's main menu, select
Configure > Advanced > Protocols > H.323.
2. Set the fields as described in
Table 37: Configuring H.323 settings
Field Name
H.323 Name
E.164
Gatekeeper Address
3. From the web interface only, select Save.
4. Select H.323 > Gatekeeper.
December 2017
From the endpoint interface
Figure 87: Configuring H.323 settings from the web interface
Table 37: Configuring H.323 settings
Description
Enter the H.323 alias of this endpoint, used to register the unit
with the gatekeeper. In H.323 calls, this name is displayed on
participant's monitors (for example: John-Smith, or 9th-Floor-
Room, or NY-Office).
Enter this endpoint's E.164 dial number.
You can use a DNS name to configure the gatekeeper address.
This allows dynamic resolution of the gatekeeper IP address and
in the case of multiple returned addresses, the endpoint registers
to the first available address.
Avaya Video Collaboration Solution for IP Office Deployment Guide
Comments on this document? infodev@avaya.com
Configuring Advanced Network Settings
on page 122.
From the web interface
on page 135.
135